Harley-Davidson Electronic Ignition Module Installation instructions
download Step 1: Switch main dashboard switch to “off” position (Ignition& light switch) Step 2: Disconnect negative (ground) cable from the Battery Step 3: Remove the Condenser and Breaker points...
View ArticleHARLEY DAVIDSON CHROME IGNITION SWITCH COVER INSTALLATION MANUAL
download This Chrome Igition Switch Cover fits all 2004 and later XL (Sportster®) model motorcycles. It is a direct replacement for the original equipment (OE) switch cover. NOTE There are no Service...
View ArticleNORTON TWIN CYLINDER MOTORCYCLES ELECTRONIC IGNITION SYSTEM INSTALLATION...
download 1. All connections must be of the highest quality, use crimped or soldered connections; twisted wires will not give a satisfactory operation. 2. Remove the petrol tank and/or seat to gain...
View ArticleThe Honda VTX 1300 Keyless Ignition Switch Installation instructions
download Remove the seat from the motorcycle.2. Lift the ignition module off of the battery cover and let it drape over the side of the motorcycle. 3. Remove the battery cover and disconnect the...
View ArticleHI-4 DUAL FIRE MOTORCYCLE IGNITION INSTALLATION INSTRUCTIONS
download Turn ignition switch off and disconnect battery ground cable. 2. Refer to Figure 3. Remove OE ignition module and wire harness (items 1-4). You will disconnect two wires at the coil (15), a...
View ArticleNORTON LIGHTWEIGHT TWIN ELECTRONIC IGNITION Installation Instructions
download 1. All connections must be of the highest quality, use crimped or soldered connections; twisted wires will not give a satisfactory operation. 2. Remove the petrol tank and/or seat to gain...
View ArticleKawasaki Sxi/ SXR Ignition twin cylinder Jet Ski ignition Installation...
download 1. Remove electronics enclosure from its mounting location. 2. Unplug and remove the OEM ignition. 3. Set the programming switches on the T3 to your settings. 4. Install the T3 Ignition in the...
View Article2008 SUZUKI GSX 1300 RK IGNITION SWITCH INSPECTION/ REPLACEMENT
download INSPECT ROUTING 1. Remove the upper and lower meter panels (refer to Service Manual page 9D-15). 2. Check if the ignition switch lead wire is clamped and routed correctly. Incorrect positions...
View ArticleHARLEY DAVIDSON VRSC FUEL TANK SIDE COVER KIT INSTALLATION INSTRUCTIONS
download INSTALLATION 1. Note the left and right areas on frame where the covers will be installed. Using a 50/50 mixture of isopropyl alcohol and water, thoroughly clean the frame tubes surrounding...
View ArticleHarley-Davidson CHROME HANDLEBAR SWITCH CAP KITS installation and REMOVAL manual
download 1. Open or remove seat according to the instructions in the Service Manual. To prevent accidental vehicle start-up, which could cause death or serious injury, disconnect battery cables...
View Article
